RANS S-20 RAVEN
TEXT MANUAL
09/01/2013
10-01
OPTIONS - AVEO STROBE INSTALLATION
(BEFORE COVERING OF WINGS)
NOTE: Installation may also be done on covered wings.
Mini-Molex Connectors (or similar) at the Wing Tip and Fuselage can make
connecting much easier.
AVEO Strobes use only 12 Volts and do not require High-Voltage wires or Power
Boxes.
1.
Install grommets in Tip Rib.
NOTE: Tip Rib was previously drilled for the
grommets.
2.
Route wires through root end of Trailing Edge Spar, through grommet in
Tip Rib and out to Wing Tip Bow. Tape wires, for covering, to the inboard
side of the Wing Tip Bow, approximately 13” aft of the leading edge. Be
certain to leave enough length to work with while wiring.
3.
Position the Strobe Mount Plates centered inside the flat area of the Wing
Tip. Be sure the Strobe will be straight when mounted. Transfer drill #40
and cleco the Mount Plate to the Wing Tip. Refer to
PARTS PAGES
Section 05F - Wing Tip Assembly.
4.
Use a Dremel tool to remove the Wing Tip material inside the Mount Plate
for the wires.
NOTE: Use the Dremel tool as a router to obtain a clean
opening.
5.
Rivet Light Mount to Wing Tip with the Nut Plate rivets.
(AFTER PAINTING OF WING AND PRE-INSTALLATION OF WING TIPS)
6.
Cut out the 4” inspection panel in outer wing skin. Pull wires taped to
inside of tip bow through inspection hole.
7.
Mount Strobes to Wing Tip and connect wiring.
(AFTER ATTACHMENT OF WINGS TO FUSELAGE)
8.
Route wires into fuselage and down aft of Station 3. Connect wires per
parts drawing and manufacturer's instructions.
9.
Check Strobe and NAV lights for proper operation.
