RANS S-20 RAVEN
TEXT MANUAL
02/17/2017
01K-03
(AFTER WINGS MOUNTED TO FUSELAGE)
15.
After wings are mounted to fuselage in final assembly, route fuel line from
each wing, down behind Station 3 and to Header tank. Secure as desired
using plastic ties. Add a clear plastic tape or split fuel hose as anti-chafe
wherever the lines contact the fuselage frame or other parts.
OPTIONAL LOW FUEL WARNING KIT
1.
Become familiar with the Optional Low Fuel Warning Kit on the Header
Tank
Parts Drawings
and collect the parts shown in the drawings.
2.
A 5/8" hole should have been located in the side of the Header Tank. If
not, refer back to
FIGURE 11B-02/912
. Replace Silicon Washer provided
with Low Fuel Warning Switch with 5/8" Rubber Washer. Install Low Fuel
Warning Switch into Header Tank. Be sure to orientate the switch to allow
electrical continuity (closed circuit) when installed. Use a continuity tester
(Ohmmeter) to be sure.
Refer to FIGURE 11B-10/912
. As the header tank
fills with fuel, the switch will open, turning off the LED Indicator Light.
3.
Install 5/8" Rubber Washer, 5/8" Steel Washer and plastic nut on outside
of tank and tighten. Double check to be sure the switch is orientated
correctly.
4.
Locate LED Indicator Light in instrument panel. Connect to Low Fuel
Warning Switch per
FIGURE 11B-10/912
. Do not forget to include a
proper sized breaker or fuse.
OPTIONAL ELECTRIC FUEL PUMP
16.
Become familiar with the Optional Electric Fuel Pump
Parts Drawings
and collect the parts shown in the drawings.
17.
Install fittings into Fuel Pump with Thread Sealant.
18.
Rivet Nut Plates to bottom of tabs under Left Seat.
19.
Bolt Fuel Pump to tabs.
20.
Connect Fuel Line from Header Tank to Fuel Pump. Connect Fuel Line
from Fuel Pump to Fuel Valve.
