RANS S-20 RAVEN
TEXT MANUAL
09/01/2013
07-07
45.
Drill the #30 holes, in the Lexan only, to #28. Clean the windshield, cuff,
and wing of any debris. Stick 1/2" Black Foam Tape to outboard edge of
Wing Cuff to help seal against Wing. Cleco the cuff in place. Install the
rivets and screws.
I
MPORTANT: Make sure to use the small brass
washers to back up the rivets.
Use extra care in placing the washers;
make sure they are up against the Lexan before pulling the rivet.
46.
Apply a small fillet of Silicon Seal to the edge of the cuff and windshield
junction. A properly installed wing cuff will contour exactly with the wing
and windshield as well as provide a watertight joint against the rain.
47.
Trim forward edge of Rubber Trim on Windshield edge to aft edge of Wing
Cuff. Glue in place as previously instructed.
