Remote Commands
R&S
®
ZNH
315
User Manual 1334.5985.02 ─ 02
The OPERation status register contains information about the calibration status of the
instrument.
The QUEStionable status register contains information about the status of the refer-
ence and local oscillator, possible overloads of the instrument and the status of limit
checks and limit margins.
The commands are independent from the operating mode.
List of commands
................................................................................................ 316
..........................................................................................316
......................................................................................316
............................................................................................316
..................................................................................... 316
......................................................................................317
......................................................................................317
STATus:QUEStionable:FREQuency[:EVENt]?
................................................................... 317
STATus:QUEStionable:LIMit[:EVENt]?
..............................................................................317
STATus:QUEStionable:POWer[:EVENt]?
.......................................................................... 317
STATus:QUEStionable:CONDition?
..................................................................................317
STATus:QUEStionable:FREQuency:CONDition?
............................................................... 318
STATus:QUEStionable:LIMit:CONDition?
..........................................................................318
STATus:QUEStionable:POWer:CONDition?
...................................................................... 318
....................................................................................... 318
STATus:QUEStionable:FREQuency:ENABle
.....................................................................318
STATus:QUEStionable:LIMit:ENABle
................................................................................318
STATus:QUEStionable:POWer:ENABle
............................................................................ 319
STATus:QUEStionable:NTRansition
................................................................................. 319
STATus:QUEStionable:FREQuency:NTRansition
.............................................................. 319
STATus:QUEStionable:LIMit:NTRansition
......................................................................... 319
STATus:QUEStionable:POWer:NTRansition
......................................................................320
STATus:QUEStionable:PTRansition
................................................................................. 320
STATus:QUEStionable:FREQuency:PTRansition
...............................................................320
STATus:QUEStionable:LIMit:PTRansition
......................................................................... 320
STATus:QUEStionable:POWer:PTRansition
......................................................................321
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined
value. All PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are detec-
ted. All NTRansition parts are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is
not detected. The ENABle part of the STATus:OPERation and STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not passed on.
Example:
STAT:PRES
Usage:
Event
Remote Control - Commands
