Remote Commands
R&S
®
ZNH
296
User Manual 1334.5985.02 ─ 02
SYSTem:BEEPer:POVerload[:STATe]
<State>
This command turns the beeper on and off when battery has reached its low-level
state.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
SYST:BEEP:POV ON
Activates the beeper state.
SYSTem:BEEPer:VOLume
<Volume>
This command sets the volume of the system beeper.
Parameters:
<Volume>
Range:
0 to 1
*RST:
0.3
Example:
SYST:BEEP:VOL 0.50
Sets the volume of the beeper to 50%.
SYSTem:BEEPer:KEY:VOLume
<Volume>
This command sets the volume of the keyboard click noise.
Parameters:
<Volume>
Range:
0 to 1
*RST:
0.3
Example:
SYST:BEEP:KEY:VOL 0.10
Sets of keyboard clicking volume to 10%.
12.6.8.5
Setting up a Network Connection
This chapter describes all commands that are used if the R&S
ZNH is part of a net-
work.
List of commands
SYSTem:COMMunicate:LAN:ETHernet
............................................................................ 296
SYSTem:COMMunicate:LAN:GATeway
............................................................................ 297
SYSTem:COMMunicate:LAN:SUBMask
............................................................................297
SYSTem:COMMunicate:SOCKet:ADDRess
...................................................................... 297
SYSTem:COMMunicate:SOCKet:DHCP[:STATe]
............................................................... 297
SYSTem:COMMunicate:SOCKet:PORT
........................................................................... 297
SYSTem:COMMunicate:LAN:ETHernet
This command queries the MAC address of the R&S
ZNH.
Remote Control - Commands
