R&S ZNH, User Manual

Page: 105 / 369

Working with the Measurement Wizard
R&S
®
ZNH
98 User Manual 1334.5985.02 ─ 02
Measurement parameters Descriptions
Comments Comments about the measurement, e.g. the external con-
ditions during the measurement.
GPS Position Displays the GPS information. See Chapter 4.2.2, "Using
the GPS Receiver" , on page 40.
"Cable Definition" Use Wizard
Cable Set-
tings Select the usage of cable characteristics as defined in the
measurement set.
Select "On" to use the predefined cable characteristics or
"Off" to redefine the cable model and cable length in
R&S
ZNH. In the case, if "On" is selected, the parameters
below will be locked.
Cable Model Cable model that you perform the measurement on. You
can define a cable model with the R&S
ZNH software, but
can also change the cable model on short notice, if neces-
sary. See
Chapter 7.2.1.3, "Creating a Cable Model" ,
on page 124.
Clear Cable
Model Deactivates the currently active cable model. See Chap-
ter 7.2.1.2, "Clear Cable Model" , on page 124.
Cable Length Length of the cable that you perform the measurement on.
"Cable Settings" Default Cali-
bration Calibration that was defined when creating the wizard set
in the R&S InstrumentView software.
Use Stored
Calibrations If set to "On", the wizard uses the calibration stored in the
R&S
ZNH. If set to "Off", the wizard uses the calibration
defined in the R&S InstrumentView software.
Measurement specification
The measurement specification dialog box displays the measurement step sequences
and the individual performed measurement status. See
Figure 6-3 .
► Select "Meas Spec" softkey.
The R&S ZNH opens the "Meas Spec" dialog box.
Performing and Configuring Measurements