Quantum P1000 Series, User Manual

Page: 119 / 132

Appendix B Installing the Slide Assembly in the Rack
Adjusting the Slide Assembly
ATL P1000 Series User’s Guide 103
Adjusting the Slide Assembly
B
Now that the slide assembly is installed in the rack, verify that:
•
The front door of the rack opens and closes freely.
•
The rear door of the rack opens and closes freely.
•
When fully extended, the slide assembly extends at least 30 in.
(76.2 cm) from the front of the rack.
If the slide assembly and rack do not meet the above requirements,
complete the procedures in this section to adjust the slide assembly.
The number of adjustments required varies from rack to rack.
Adjusting the Slide
Assembly on the
Mounting Brackets
B
To adjust the slide assembly on the mounting brackets:
Procedure
1
Loosen the outer nuts on both sides of the slide assembly (see
figure 56).
These nuts secure the mounting brackets to the slide rails.
Figure 56 Loosening the
Outer Nuts
Outer nuts
Outer nuts