Quantum P1000 Series, User Manual

Page: 39 / 132

Chapter 2 Installing the P1000 Library
Unpacking the P1000
ATL P1000 Series User’s Guide 23
Procedure (continued)
6
Detach the ramp and place it on top of the pallet.
7
Roll the library to the installation site.
8
Save the shipping carton, bag, foam supports, ramp, and pallet for
future use.
These items are required to package the library for reshipment.
Removing a Rack-mount Library from the Pallet
2
Note: The instructions in this section assume you have already installed the
slide assembly in the rack. If you have not, do so now, following the
instructions in appendix B.
To remove a rack-mount library from the pallet:
Procedure
1
Remove the plastic bag enclosing the library:
a
Cut along the front seam of the plastic bag.
b
Continue to cut all the way to the back of the library.
c
Fold the bag out of the way.
2
Pull the slide tray forward in the rack so it is fully extended.
Warning: The rack may tip forward when you extend the slide tray or
place the library on the slide tray. If rack stabilizing feet are
present, extend them during this procedure. If the rack
does not have stabilizing feet, use extreme caution when
extending the slide tray and mounting the P1000 in the
rack.
3
With the help of a second person, lift the library from the pallet (see
figure 17 on page 24).