Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing the Node Integrated Storage Controller
118
Quantum DXi6902 User’s Guide
2
Navigate to the
Status > Hardware > Details > Storage Arrays
page.
3
Under
Storage Arrays
, click
a0
, and then note the status of the
PERC H710 below (see
Figure 67 Checking Integrated
Storage Controller Status
Removing a Failed Integrated Storage Controller
To remove the integrated storage controller from the DXi6902 Node:
1
Shut down the system (see
Turning On and Shutting Down the
2
3
Remove the expansion card riser 1 (see
).
4
Push down the two release levers at the edge of the integrated
storage controller card to disengage the card from the connector
(see
).
5
Angle the card so that the other end of the card disengages from
the storage controller card holder on the system board.
Summary of Contents for DXi6902
