Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Node Hard Drives
Quantum DXi6902 User’s Guide
89
Figure 47 Removing and
Installing a Node Hard Drive
Installing a Replacement Drive in the Node
To install the replacement hard drive in the DXi6902 Node:
Caution:
Use only the Quantum-supplied replacement drive to
perform the replacement procedure. Do
not
use any other
drive (not even one taken from another DXi).
Caution:
When installing a hard drive, ensure that the adjacent
drives are fully installed. Inserting a hard-drive carrier and
attempting to lock its handle next to a partially installed
carrier can damage the partially installed carrier's shield
spring and make it unusable.
1
Press the release button on the front of the hard-drive carrier and
open the hard-drive carrier handle (see
)..
2
Insert the hard-drive carrier into the hard-drive slot until the carrier
connects with the backplane.
3
Close the hard-drive carrier handle to lock the hard drive in place.
• It may take up to 30 seconds for the system to detect that a
failed drive was removed and a new drive was inserted.
• The status indicator for all drives in the Node will blink green
while the drive is rebuilding.
Hard drive handle
Hard drive carrier
Release button
Summary of Contents for DXi6902
