Setup
Connecting to a Computer or Network
CubiScan 110-T
11
4. Locate a free USB port on your computer and connect the other end of
the USB cable to the port.
When you have completed these steps, the CubiScan 110-T should
communicate with a computer.
Ethernet Connection
Complete the following steps to connect the CubiScan 110-T to a computer
using an Ethernet connection.
1. Place the computer in its permanent location, generally close to the
CubiScan. (Refer to
for more information.)
2. Route the Ethernet cable under the base so it cannot be crushed, bent,
or pulled loose.
3. The CubiScan controller is located just behind the control panel at the
front of the base. Connect one end of the Ethernet cable to the Ethernet
connector on the back of the CubiScan controller, as shown below. Push
the connector in until it locks. There should be an audible snap when it
locks.
Figure 6
Back of Controller
