Setup
Connecting Power
CubiScan 110-T
9
•
If a computer is used, place it as close to the CubiScan as possible. The
operator needs to use the keyboard or mouse on the computer while
cubing and weighing packages using the CubiScan 110-T.
•
Orient the CubiScan so the control panel faces the operator.
After meeting the above criteria as best as possible, complete the following
steps to place and level the CubiScan 110-T.
1. Place the CubiScan 110-T on a solid, stable surface. Be sure that nothing
touches the back wall or top platter, as this may affect the scale.
2. Place the bubble level provided in the center of the scale platter.
3. Adjust the five leveling feet under the CubiScan 110-T to level the scale.
Make sure all feet are touching the supporting surface.
An optional cart and portable power supply are available from Quantronix
to create a completely mobile cubing, weighing, and identification
workstation.
Connecting Power
The CubiScan 110-T uses an external AC power adapter. Take the following
steps to connect power to the CubiScan.
1. Locate the AC power adapter, which is bundled inside the CubiScan
base. The DC power cord from the power adapter is attached to the
controller box.
2. Locate the AC power cord (supplied), and connect it to the AC power
adapter.
3. Route the AC power cord under the CubiScan base so it cannot be
crushed, bent, or pulled loose.
4. Connect the other end of the AC power cord to a standard power strip
equipped with an ON/OFF switch.
5. Use the power strip switch to turn the CubiScan on and off (see
“Turning on the CubiScan” on page 10
).
