Setup
Turning on the CubiScan
CubiScan 110-T
10
Turning on the CubiScan
Specific procedures must be followed each time you turn on the CubiScan
110-T, as follows:
1. Make sure there are no packages or other objects on the CubiScan
platform.
2. Turn on the CubiScan 110-T via the power strip (see
The CubiScan performs self-calibration and diagnostic procedures that
take about five seconds. Do not touch the CubiScan platform during
these five seconds.
Connecting to a Computer or Network
To operate the CubiScan 110-T, you can connect it to a computer or a
network, or you can use the control panel, as follows:
•
Connect it via a USB to USB cable. Use Qbit software on the computer to
run the CubiScan 110-T.
•
Connect it to a host system via a standard 10-BaseT Ethernet TCP/IP
port.
•
Connect it to a PC using a serial RS-232 cable.
USB Connection
Complete the following steps to connect the CubiScan 110-T to a computer
using a USB connection. The USB connection method is the recommended
method, and all materials needed for communicating with a computer are
supplied.
1. Place the computer in its permanent location, generally close to the
CubiScan. (Refer to
for more information.)
2. Route the USB cable under the base so it cannot be crushed, bent, or
pulled loose.
3. The CubiScan controller is located just behind the control panel at the
front of the base. Connect one end of the USB cable to the USB
connector on the back of the CubiScan controller, as shown below.
