![PRONAR RC2100 Translation Of The Original Copy Of The Manual Download Page 61](http://html.mh-extra.com/html/pronar/rc2100/rc2100_translation-of-the-original-copy-of-the-manual_1617427061.webp)
SECTION 4
Pronar RC2100
4.3
4.1.2 PREPARE A TRAILER FOR FIRST HITCHING TO TRACTOR
Preparation
Check all the trailer's lubrication points, lubricate the machine as needed
according to recommendations provided in section 5.
Check if the nuts and bolts fixing the wheels are properly tightened.
Drain air tank of the brake system.
Ensure that pneumatic, hydraulic and electric connections in agricultural
tractor are according to the requirements, if not the trailer should not be
hitched to the tractor.
Adjust the height of the drawbar setting or location of higher transport hitch.
a detailed description can be found in section 5.
Test drive
If all the above checks have been performed and there is no doubt as to the trailer's good
technical condition, it can be connected to tractor. Start the tractor, check all systems and
conduct test run of trailer without load (no load in load box). It is recommended that the
inspection is conducted by two people, one of which should always remain in the tractor cab.
Test start should be conducted according to the sequence shown below.
Connect trailer to appropriate hitch on agricultural tractor.
Connect brake, electrical and hydraulic system lines.
Switch on individual lights, check correct operation of electrical system.
Check if the ramps' hydraulic system and the hydraulic winch operate
correctly.
When moving off check if the main brakes operate correctly.
Perform test drive.
If during test run worrying symptoms occur such as:
•
noise and abnormal sounds originating from the abrasion of moving elements of
the trailer design,
•
hydraulic oil leak,
Summary of Contents for RC2100
