PRONAR RC2100, Translation Of The Original Copy Of The Manual

Page: 101 / 125

SECTION 5 Pronar RC2100
5.19
DANGER
Before proceeding to dismantle filter, reduce pressure in supply line. While disengaging
filter slide gate, hold cover with other hand. Stand away from filter cover vertical direction.
Depending on trailer working conditions, but not less than once in three months, take out and
clean air filter inserts, which are located in pneumatic system connection conduits. Inserts are
used many times and are not subject to changing unless they are mechanically damaged.
REQUIRED SERVICE ACTIONS
Reduce pressure in supply line.
Reduction of pressuring line may be achieved by pressing the head of
the pneumatic connection to resistance point.
Remove securing slide (1) – figure (5.8 ) .
Hold the filter cover (2) with the other hand. After removing slide lock,
the cover is pushed off by the spring, in the filter housing.
The insert and the filter body should be carefully washed out and blown
through with compressed air. Assembly should be done in reverse order.
Cleaning the air filter (filters):
•
every 3 months of use,
5.3.4 DRAINING WATER FROM AIR TANK
REQUIRED SERVICE ACTIONS
Open out drain valve (2) located in lower part of tank (1) – Figure (5.9).
The compressed air in the tank causes the removal of water to the
exterior.
After release valve stem should automatically close and stop airflow from tank.
In the event, that the valve stem resists returning to its setting, then
the whole drain valve must be unscrewed and cleaned, or replaced (if
it is damaged) - see section 5.3.5.