PRIMERGY BladeFrame BF200, Initial Setup Manual

Page: 98 / 115

Initial Setup Guide cBlade ES
5-20 Release 5.0
To change an internal IP address of a BladeFrame BF200:
1. Connect your console to Control Blade 1.
2. Log on as root .
3. Change the internal IP addresses using the
intnet
command.
Enter all addresses in the same command line, in the following
format:
# intnet -N Network_IP -M Netmask -B Broadcast_IP
where:
Network_IP is the IP address of the internal management
network.
Netmask
is the network mask IP address.
Broadcast_IP
is the broadcast address of the internal
management network.
4. The prompt displays
Activate internal network
configuration (y/n). Type y to configure the new
addresses you entered in the preceding step, or type
n
to discard
the addresses.
5. Verify that addresses have changed, by entering the following:
# intnet
This displays the current IP address for each of the interfaces.
Control Blade 2 automatically picks up these address changes from
Control Blade 1.
To confirm this:
1. Connect your console to Control Blade 2.
2. Log on as
root
if you are not already logged on.
Multicast port 9000
Table 5.3 Internal Management IP Addresses
Internal Management Address IP Address (Default Value)