PRIMERGY BladeFrame BF200, Initial Setup Manual

Page: 34 / 115

Initial Setup Guide cBlade ES
2-14 Release 5.0
CE Certificate
FCC Class A
Compliance
Statement If there is an FCC statement on the device, then:
The following statement applies to the products covered in this
manual, unless otherwise specified herein. The statement for other
products will appear in the accompanying documentation.
Note: This equipment has been tested and found to comply with the
limits for a “Class A” digital device, pursuant to Part 15 of the FCC
rules and meets all requirements of the Canadian Interference-
Causing Equipment Standard
ICES-003 for digital apparatus. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in strict accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no warranty that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and the receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/T.V. technician
for help.
The shipped version of this device complies with the
requirements of the EEC directives 89/336/EEC
“Electromagnetic compatibility” and 73/23/EEC “Low
voltage directive”. The device therefore qualifies for the CE
certificate (CE=Communauté Européenne).