Installing the Hardware
Release 5.0
3-25
To install a pBlade:
1.
Remove the pBlade from its shipping carton.
2.
Make sure the power to the BladeFrame BF200 is turned off at
the power breaker on the rear panel.
3.
Align the pBlade rails with the BladeFrame BF200 rails in the
required pBlade slot (slots 2 through 7). The BladeLatch is at the
bottom, as
Figure 3.15
shows.
Figure 3.15 Installing a Blade
4.
Push the pBlade into the BladeFrame BF200 until its
BladeLatch “pops” out from the face of the blade.
Note:
Do not push on the BladeLatch. Push only on the front
bezel. The pBlades don’t require as much force as the cBlades.
5. Firmly
push the BladeLatch back into the face of the bezel until
it stops.
6.
Release the BladeLatch and allow it to spring back until it is
flush (or near flush) with the front of the blade.
Summary of Contents for BladeFrame BF200
