Initial Setup Guide cBlade ES
3-8
Release 5.0
3.
Push the extender to the left as far as it will go (2) then tighten
the three bolts (3).
Note:
If you plan to install more than one BladeFrame BF200
in the rack, locate the first set of side rails in the lowest position
in the rack to ensure the stability of the rack.
4.
Repeat the procedure also for the second side rail.
For mounting the left side rail in the PRIMECENTER Rack, the
provided support bracket must first be mounted on the rear left
support upright. The bracket must be mounted level with the
lower edge of the device.
Figure 3.4 Mounting the support bracket
5.
Mount the support bracket at the appropriate height on the left
rear support upright as described in the Technical Manual of the
PRIMECENTER Rack.
Note:
For better orientation the height units are marked on the
support uprights (PRIMCENTER Rack only).
6.
Secure the bracket with two M4x10 centering screws.
Summary of Contents for BladeFrame BF200
