EFX 885, 835, 825
Service Manual 20039-166
Page 155
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Diagram 10.11.2 - Stairarm Wheel
7.
Slide the replacement wheel onto the stairarm axle. Fasten the wheel with the hardware removed in step 6.
Apply blue loctite to the wheel mounting screws and torque them to 180 inch pounds.
8.
Repeat the procedure in steps 6 and 7 for each wheel being replaced.
9.
Align the T-nuts on the ramp trim(s) with the channel in the bottom front of the ramp. Slide the trim onto
the ramp while feeding each T-nut into the ramp channel. Do not tighten the trim fastening screws at this
time. Repeat this procedure with the remaining trim strip, if required.
10.
Set the ramp end cap at its mounting position and fasten it with the screws removed in step 3.
11.
Align the ramp trim(s) with the ramp end cap and tighten the five trim mounting screws.
12.
Set the ramp center cover at its mounting position and press downward to snap it onto place.
13.
Replace the lift cover per Procedure 10.2.
Stairarm
Wheel
Mounting
Screw
Summary of Contents for EFX 825
Page 15: ......
