EFX 885, 835, 825
Service Manual 20039-166
Page 31
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
6.
Remove the console by lifting it off the mounting hook.
7.
Install the replacement console. In the back of the P80 console there is a large black steel support called the
Armor. At the bottom of Armor there is a notch about ¼ inches in depth and about 1½ inches across.
See
Diagram 3.12.6.
Set the console notch over the over the mounting hook.
Note:
Before releasing the console
insure the notch is securely seated over the mounting hook.
See Diagram 3.12.4
Diagram 3.12.6
8.
Route the RF coax cable down below the tuner and out the right bottom side of the armor. This is easier if you
straighten the cable and gently push it in the direction as shown in diagram 3.11.7. Feed about 10 inches of cable
out though the plastic using your finger as a guide.
9.
Bring the coax cable up over the top of the armor and connect it to the flexible cable attached to the tuner.
See
Diagram 3.12.8.
10.
Secure the RF coax connectors in place with a zip tie.
Note:
It is important that the connection be tied to the
frame in this location to prevent the cable from being pinched, and the possibility of rattling noises during use.
Be sure to secure the zip tie on the connector and not on the cable.
See Diagram 3.12.9.
Diagram 3.12.7
Diagram 3.12.8
Diagram 3.12.9
Cable Wire Tie
Console Armor
Console Mounting Notch
Summary of Contents for EFX 825
Page 15: ......
