EFX 885, 835, 825
Service Manual 20039-166
Page 160
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
5.
Remove the ramp from the EFX.
6.
Remove the two screws that fasten the rear ramp end cap to the ramp. Set the rear ramp end cap at its
mounting position on the replacement ramp and fasten with the screws removed above.
7.
Set the replacement ramp in its mounting position and hand start ramp pivot mounting bolts removed in
step 3. Do not tighten them at this time.
8.
Slide incline yoke into its mounting position in the ramp and fasten it with the hardware removed in step 4.
9.
Apply blue loctite to the four ramp pivot bolts (hand started in step 7) and torque them to 480 inch pounds
(40 foot pounds).
10.
Slide the stairarm onto the crankarm and set the stairarm in its ramp track. Fasten the stairarm to the
crankarm with the retaining ring removed in step 7.
11.
Replace the stairarm connector per Procedure 10.16.
12.
Align the T-nuts on the ramp trim(s) with the channel in the bottom front of the ramp. Slide the trim onto
the ramp while feeding each T-nut into the ramp channel. Do not tighten the trim fastening screws at this
time. Repeat this procedure with the remaining trim strip, if required.
13.
Set the ramp end cap at its mounting position and fasten it with the screws removed in step 3.
14.
Align the ramp trim(s) with the ramp end cap and tighten the five trim mounting screws.
15.
Set the ramp center cover at its mounting position and press downward to snap it onto place.
16.
Replace the lift cove per Procedure 10.2.
Summary of Contents for EFX 825
Page 15: ......
