EFX 885, 835, 825
Service Manual 20039-166
Page 162
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 10.16 Replacing a Stairarm Connector
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in Section One, Things You
Should Know.
1.
Remove the plastic cap from the stairarm end of the stairarm connector. Remove the bolt that fastens the
stairarm connector to the stairarm. Refer to Diagram 10.5.1. There are two washers and a spacer in the
stairarm connector.
2.
Remove the plastic cap from the inside lower end of the handlebar. Refer to Diagram 10.15.1. Remove the
bolt that fastens the handlebar to the stairarm connector. There are two washers and a spacer in the
stairarm connector.
3.
Remove the stairarm connector.
4.
Slide the spacer into the bushing in the rear of the stairarm connector and place a washer on each side of
the spacer. Set the stairarm connector at its mounting position and fasten it with the bolt removed in step
3. Securely tighten the stairarm connector bolt. Snap the plastic cap removed in step 3 into the stairarm
connector.
5.
Slide the spacer into the bushing in the front of the stairarm connector and place a washer on each side of
the spacer. Position the handlebar and stairarm connector at their mounting positions and hand start the
mounting bolt.
6.
Securely tighten the handlebar to stairarm connector bolt. Replace the plastic cap on the stairarm
connector.
Summary of Contents for EFX 825
Page 15: ......
