EFX 885, 835, 825
Service Manual 20039-166
Page 33
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Diagram 3.12.13
15.
Make sure that all cables are fully and securely connected, and that cables are tied back properly. Make sure
any extra cabling is pulled down through the neck and along the front of the dash, making sure the cables are
routed through the plastic guides inside the neck.
16.
Tilt the control console backward (toward yourself) until the tab on the top edge of the armor slides along the
top edge of the console mount and the screw holes align properly.
17.
Secure the console to the plate using the four flat head
5
/
8
inch long screws.
Note:
You must use
5
/
8
inch long
screws. If the screws are too short the console will not be properly grounded. If the screws are too long it is
possible to damage the internal wiring.
18.
Tighten the screws fully using a
⁵
/
₃₂
-inch hex wrench.
19.
Replace the rear vent cover.
HR Cable
HR PCA
Summary of Contents for EFX 825
Page 15: ......
