EFX 885, 835, 825
Service Manual 20039-166
Page 149
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 10.6 Replacing an Incline Motor
1.
Remove upper and front cover sections per Procedure 10.2.
2.
Remove the hitch pin from the clevis at the lower incline motor mount. Remove the clevis pin from the
lower incline motor mount.
3.
Carefully lift the incline motor out of its mount and set it on the floor in front of the EFX, Refer to Diagram
10.6.1.
Diagram 10.6.1 - Incline Motor
4.
Disconnect the intermediate cable from the incline motor cable.
5.
Remove the two bolts that fasten the incline motor yoke into the ramp. Refer to Diagram 10.14.2.
6.
Carefully, slide the incline motor yoke out of the ramp and lower the ramp until it is resting on the frame.
7.
8.
9.
Connect t
10.
Mount the incline motor to the EFX frame with the clevis and hitch pins removed in step 2.
11.
Calibrate the incline motor per Procedure 8.3.
12.
Replace front and upper cover sections per Procedure 10.2.
13.
Check the operation of the EFX as described in Section Seven.
Incline Motor
Intermediate Cable
Hitch Pin
Clevis Pin
Summary of Contents for EFX 825
Page 15: ......
