EFX 885, 835, 825
Service Manual 20039-166
Page 157
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 10.13 Replacing the Stairarm
1.
Remove the left and right side rear cover.
2.
is on the inside and must be
accessed from the opposite side of the EFX. Carefully, rotate the stairarm to a position just forward of
3.
Remove the lift cover per Procedure 10.2.
4.
Grasp the center ramp cover and lift it upwards to unsnap it from the ramp. Remove the center ramp cover
from the EFX and set it aside.
5.
Remove the two screws that fasten the ramp end cap to the ramp. Remove the ramp end cap. Refer to
Diagram 10.12.1.
6.
The left side and/or right side ramp trim will need to be removed in order to access the stairarm wheels.
7.
Loosen, but do not remove, the five screws that fasten ramp trim(s) required to access the wheel(s) being
replaced. Slide the ramp trim(s) off the front of the ramp.
8.
Remove the plastic cap from the stairarm connector. Remove the bolt that fastens the stairarm connector
to the stairarm. Retain the bolt, two washers, a steel spacer and a large black spacer for later use. Refer to
Diagram 10.13.1.
Diagram 10.13.1 - Stairarm and Stairarm Connector
1.
Remove the retaining ring that fastens the stairarm to the crankarm and remove the stairarm from the EFX.
2.
Remove the stairarm pedal per Procedure 10.12 and install it on the replacement stairarm.
3.
Remove both wheels and slide them onto t
mounting screws and torque the wheel mounting screws to 180 inch pounds.
Mounting
Bolt
Stairarm
Connector
Plastic
Cap
Retaining
Ring
Stairarm
Summary of Contents for EFX 825
Page 15: ......
