Preparing the pneumatic tool
18
Connecting the pneumatic tool to the compressed air
supply
You can connect the pneumatic tool to a compressed air system or
to compressed air cartridge.
If you connect the pneumatic tool to a compressed air system, you
can economically execute frequent driving processes at the same
location. Moreover you can feed lubricating oil into the pneumatic
tool via the compressed air system.
When you connect the pneumatic tool to a compressed air cartridge
you are independent of a stationary system.
You can connect the pneumatic tool to both sources of
compressed air at the same time. In this case the compressed
air in the cartridge will be consumed first. Then the
compressed air will be consumed from the compressed air
system.
The permissible operating pressure of the pneumatic tool is 8.3 bar.
If the permissible operating pressure is exceeded then the pointer in
the manometer for the operating pressure is in the red area.
This can occur under the following conditions:
If both safety valves are defective and
You have connected the pneumatic tool to a compressed air
system with excessive pressure, or to an unsuitable compressed
air cartridge.
WARNING
Explosion hazard when exceeding the
maximum operating pressure.
In this case disconnect the pneumatic tool
immediately from the compressed air
supply.
