Preparing the pneumatic tool
28
Check the function
Proceed as follows for trouble-free pneumatic tool function:
CAUTION
A hazard of injury or property damage exists
when operating the pneumatic tool.
Comply with the safety instructions in the
section "Operating the pneumatic tool "
starting on page 29.
Place the nose of the pneumatic tool on a piece of wood that is at
least ten centimeters thick.
Release the pneumatic tool (see section "Driving nails" starting on
page 34).
In this process check the following characteristics:
-
Release is only executed when the safety device is
depressed.
-
One nail must be driven into the piece of wood with each
release.
-
The air discharge should not blow into your face.
To obtain the desired depth-of-drive, change the operating
pressure, or if necessary the adjustment on the lock clip (see
page 31).
Repeat these steps as necessary.
The pneumatic tool is now ready for operation.
