Operating the pneumatic tool
38
Interrupting operation
You can hang up the pneumatic tool for short interruptions in
operation. There is an M8 x 1.25 thread on the housing head for this
purpose.
CAUTION
The pneumatic tool can be damaged if the
suspension hook is not firmly anchored.
Only use hooks with at least 15 kg load
capacity.
Screw the hook hand tight.
Only hang the pneumatic tool on a mount
that has a bearing capacity of at least 15
kg.
Screw a hook with M8 x 1.25 thread and a bearing capacity of at
least 15 kg into the threaded connection.
WARNING
Inadvertent release is possible if the tool is in
the "bump fire" release setting and the tool
falls down.
Only hang up the pneumatic tool when it is
in the "single shot" release setting.
Never position yourself under a suspended
pneumatic tool.
Set the selector switch to "single shot" (see page 29).
Hook the pneumatic tool on a mount with sufficient bearing
capacity.
