Operating the pneumatic tool
32
Pull the regulator for the operating pressure to the right, away
from the handle (1.).
Turn the regulator for the operating pressure until the pointer of
the manometer is approximately in the middle of the green area
(2.).
-
To increase the operating pressure turn the operating
pressure regulator clockwise.
-
To reduce the operating pressure turn the operating pressure
regulator counter-clockwise.
The minimum operating pressure has now been set.
Now press the nose of the tool against a trial piece of wood that
has the same characteristics as the wood that you want to
process.
Release the pneumatic tool once (see page 36).
Then proceed as follows to adjust the desired operating pressure
and depth-of-drive:
To increase the operating pressure and depth-of-drive, turn the
regulator for operating pressure clockwise.
To reduce the operating pressure and depth-of-drive turn the
regulator for the operating pressure counter-clockwise.
