Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 674 / 747

10.50
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
IDD – USB FLASH DRIVE
RECOMMENDATIONS
Polaris recommends using a Scandisk® or similar USB
flash drive with a minimum of 4 GB available memory.
USB Flash Drive Notes / Troubleshooting
• The flash drive must be formatted as FAT 32. Use
Quick Format on the PC to format the drive as FAT 32.
IMPORTANT
Formatting the flash drive will erase all of its contents.
• Use a dedicated USB flash drive with only Ride
Command Maps-Trails / IDD update files on the drive.
• Don’t create file folders on the flash drive. Download
the Ride Command Maps-Trails or IDD update files to
the root level of the drive.
• When removing the flash drive from the PC or laptop,
use the “Safely Remove Hardware and Eject Media”
tool provided by the operating system.
• Updating the IDD does not require the engine to be
running if the snowmobile is equipped with a battery.
Verify the battery is fully-charged.
• If errors are encountered during the update process or
the IDD does not recognize the USB flash drive, follow
these steps:
1. Re-format the drive as FAT 32.
2. Download the update file again from Ride
Command.
3. Re-attempt to update the IDD.
4. If the IDD does not recognize the USB flash drive,
try the procedure with a different flash drive.
PIDD USER NOTES / TROUBLESHOOTING
User Notes:
ORV Icons Displayed on Screen:
• PIDD has not been initialized with the vehicle’s ECU.
the PIDD will auto-initialize after the engine is started
and the PIDD completes the booting process.
Security Settings / Diagnostic Trouble Codes (DTCs) Not
Shown:
• Security has not been enabled. Use Digital Wrench to
enable security.
• ECU is not powered. Start engine or supply 12V
battery power to the ECU PWR and Gauge PWR test
connectors to supply power to ECU and Gauge.
NOTICE
Some DTCs will not set unless the engine is running.
PIDD Update Process / Duration:
• The PIDD update process can take upwards of 30
minutes to complete and is dependant on update file
size.
• If the snowmobile is not equipped with a battery, the
engine must be running to perform the PIDD update
procedure. Allow the engine idle to stabilize after start-
up prior to starting the procedure. Never run the
engine in an enclosed space. Run the engine is a well
ventilated area.
• The update indicator bar shown on the screen will not
always indicate an accurate time-to-complete file
install status. Reference the rotating indicator in the
upper left corner of the screen during the update. If the
indicator is rotating, the PIDD is updating. Do not turn
the key to OFF or disconnect battery power during the
update.
BATTERY / ELECTRICAL