Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 285 / 747

3
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
3.85
LOWER CONNECTING ROD BEARING
INSPECTION
Measure the side clearance for the big end of the
connecting rod with a feeler gauge on both sides of the
connecting rod. The side clearance on either side of the
connecting rod cannot exceed the connecting rod side
clearance specification. The difference between the two
clearance measurements cannot exceed the maximum
clearance differential specification.
MEASUREMENT
Connecting Rod Side Clearance:
0.030 in (0.762 mm)
Rotate the connecting rod on the crankshaft and feel for
any rough spots. Check radial end play in rod by
supporting rod against one thrust washer and alternately
applying up and down pressure. Replace bearing, pin,
and thrust washers if side clearance is excessive or if
there is any up and down movement detectable in the big
end bearing.
MAIN BEARING INSPECTION
Clean the crankshaft, oil main, and connecting rod
bearings thoroughly with Polaris engine oil. Carefully
check each main bearing
q
on the crankshaft.
Due to extremely close tolerances, the bearings must be
inspected visually and by feel. Look for signs of
discoloration, scoring or galling. Turn the outer race of
each bearing. The bearings should turn smoothly and
quietly. The inner race of each bearing should fit tightly
on the crankshaft. The outer race should be firm with
minimal side to side movement and no detectable up and
down movement. Replace any loose or rough bearings.
ENGINE / COOLING / EXHAUST