Polaris 850 PRO-RMK 155 2.6" QD 2021, Manual

Page: 670 / 747

10.46
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
DIAGNOSTIC DISPLAY MODE
The diagnostic display mode is for informational
purposes only. Your POLARIS dealer can perform all
major repairs.
The diagnostic mode is accessible only when the check
engine warning indicator is illuminated
and a diagnostic
code is active.
Do not stop the engine if you want to view the active
code (failure code). Active codes cannot be retrieved if
the power is interrupted to the instrument cluster. The
codes will become inactive codes if the power is
interrupted. Inactive codes are stored in the history of the
unit. Please see your POLARIS dealer to retrieve
inactive codes.
Use the following procedure to view active codes.
1. Do not stop the engine.
2. Press and hold the center button on the
instrument cluster to enter the Options Menu.
3. Press and release the MODE button until DIAGCODE
appears in the information display area. The
Diagnostic display mode will appear in the Options
Menu if there is an active trouble code.
TIP
When the diagnostic mode is displayed, the check
engine warning indicator will begin to flash.
4. A set of two numbers will appear in the display.
• The 2 - 6 digit suspect parameter number (SPN) in
the information display area indicates which
component is generating the fault code.
• The 1 - 2 digit failure mode indicator (FMI) number
in the odometer area indicates the fault mode, such
as open or short circuit.
5. More than one fault may be active. Press and hold
the SET button or SET switch for two seconds to
toggle to the next active code. Repeat until all codes
are retrieved.
6. See Diagnostic Display Code Definitions for code
definitions and failure descriptions.
PLAYBACK FUNCTION
The playback function allows the rider to record and play
back engine speed, vehicle speed and throttle position
sensor information for up to three minutes.
TO RECORD
1. Press and hold the center button on the
instrument cluster to enter the Options Menu.
2. Press and release the MODE button until PLAYBACK
appears in the information display area.
3. Press and release the SET button.
RECORD will appear in the information display area.
4. To begin recording, Press and release the SET
button.
The playback indicator will flash while recording is in
progress. Recording is complete when the light stops
flashing.
NOTICE
To stop recording at any time during the recording
process, press and release the SET button.
BATTERY / ELECTRICAL