8
EN001 H01
2. Introduction
Different variants of the electrofusion control unit
This instruction manual describes several different variants of the electrofusion control unit. These
variants differ in the range of available functions and in the number of menu entries. The
differences are pointed out where necessary. Please check which variant you have.
2.1 Scope of application
The electrofusion control units of type Monomatic (Bluetooth) and Monomatic Data USB (Bluetooth) are
solely meant for the welding of thermoplastic pipes (e.g. made of PE-HD, PE80, PE100 or PP) when used
with electrofusion fittings that have an input voltage of less than 48 V. These devices are conforming to the
standards DVS 2208-1 and ISO 12176-2, of which the applicable standards for the electrofusion fittings to be
used are derived from.
The electrofusion control units of type Monomatic (Bluetooth) and Monomatic Data USB (Bluetooth) feature a
built-in Bluetooth module for the communication with the "ElectroFusion Studio" app.
It is not allowed to use the electrofusion control unit for any application not covered by the above stated
terms.
Intended use
It is not allowed to use the electrofusion control unit for any application not covered by the above
stated terms. Modifying the electrofusion control unit without consulting the manufacturer is
forbidden and shall be considered as improper use.
The manufacturer is not liable for the use of the electrofusion control unit outside of the
intended use! When in doubt always consult your supplier or the manufacturer.
