EN001 H01
41
Step
Action
6
End of data transmission when transmitting reports per job number
6.1
After successful data transfer of the reports for one job number the following display will be shown:
Display after the transfer of the reports for one job
number
Row 1 shows the name of the folder in which the reports are stored on the USB memory stick, as
well as the message "OK".
Row 2 shows the file, in which the reports are written.
You can return to the main display by pressing the red stop button.
By pressing the green start button you are taken to the deletion prompt for the transmitted reports.
Erase prompt for the reports of this job number.
7 OPT
OPTIONAL: Deletion of the transferred reports
7.1
The prompt "Erase ?" which is displayed together with the job number offers the possibility to
delete the last transmitted reports from the memory of the electrofusion control unit.
7.2
If you want to erase the reports, press the enter button. A confirmation prompt "Are you sure?" will
be displayed.
7.3
If you confirm this prompt by pressing the green start button, the respective reports will be erased.
The display will then show the main display.
7 OPT
OPTIONAL: Leaving the transmitted reports in the device's memory
7.1
If you do not want to delete the reports and leave them stored in the memory of the device, press
the red stop button. The display then shows again the selection of the job numbers.
Attention!
The deletion can take up to a couple of minutes.
To avoid possible errors in the memory management or loss of data, ensure that the
electrofusion control unit is not cut off from power during deletion of the reports. This could
lead to the destruction of the electronics!
NEVER switch the electrofusion control unit off during the deletion of welding reports.
PF / OK
PF000006.PDF
+++++Job ++++
Erase ?
