EN001 H01
45
12.4 Erase reports?*
This function enables you to delete the reports that are stored in the electrofusion control unit. The reports
can be deleted per job number. You can press the red stop button at any time. This will take you back to the
main display.
Attention!
You can lock this option so that you are prompted for an access code when trying to access it.
Refer to chapter Code Del. "" of the system configuration.
Attention!
If you erase the reports of one job number then you will automatically delete the job number from
the memory of the device. If you still need the respective job number, you must enter it again after
the deletion.
Attention!
The deletion can take up to a couple of minutes.
To avoid possible errors in the memory management or loss of data, ensure that the
electrofusion control unit is not cut off from power during deletion of the reports. This could
lead to the destruction of the electronics!
NEVER switch the electrofusion control unit off during the deletion of welding reports.
Step
Action
1
Accessong the menu "Erase reports"
1.1
Connect the printer with the USB interface of the electrofusion control unit.
1.2
Select the entry "Erase reports" in the function menu, using the ▲
-
and ▼
-buttons.
1.2
Then press the enter button to select the function.
1.3
OPT
OPTIONAL: If you have locked the erase function by activating the "Code Del." option in the
system configuration you will be prompted for an unlocking- resp. supervisor code. The
manufacturer can provide you with an unlocking- resp. supervisor code on request.
Read in the unlocking- resp. supervisor code using the reading pen/scanner or press the enter
button to do the input by using the letter field. If you use the letter field, press the green start
button after the input to confirm the entered code.
1.3
OPT
OPTIONAL: If you have not locked the erase function in the system configuration ("Code Del." is
deactivated by default) a display with job numbers will be shown after pressing the enter button.
2
The menu "Erase reports"
2.1
Select the job number that you want to erase and press the green start button.
Display in the menu "Erase reports"
▲ ▼
Cycles through the already entered job numbers.
Green start button
Erase reports of the displayed job number.
Red stop button
Abort and return to the main display.
*) Only with electrofusion control units that have data recording capability.
Job no.
TEST
2
