EN001 H01
37
12.2 Job no.*
To show the currently active 40-digit job number and to change it, select the function "Job no."in the function
menu. Now the currently set job number (commission number) is displayed. The last row of the display
shows the number of reports that already have been stored under this job number. In this menu you can
select a job number under which the following reports will be stored. Alternatively you can create a new job
number with the help of a letter field.
Step
Action
1
Displaying the job numbers
1.1
Select the entry "Job no." in the function menu, using the ▲
-
and ▼
-buttons.
1.2
Then press the enter button to select the function.
2
The menu "Job no."
Setting the job number
▲ ▼
Cycles through the already entered job numbers.
Enter button
Creates a new job number
Green start button
Sets the currently displayed job number active.
Red stop button
Abort and return to the main display.
You have three ways of changing the job number (commission number) under which the following
reports are stored.
2.1
OPTIONAL: Reading in a barcode that contains the job number (commission number).
If for example you have a contract with a commission number available as barcode you can read
this in as job number. The maximum length of the barcode may not exceed 40 digits
(alphanumerical). Preferably, a barcode of type Code128, 2/5i or Code39 extended should be
used.
The prompt that follows the successful reading in of a barcode should be acknowledged by
pressing the green start button to accept the barcode. It will then be copied to the internal list and
set as currently active job number (commission number). Finish your selection by pressing the
green start button.
2.1
OPTIONAL: Selecting an already existing job number and activating it.
You can browse through the list of already entered job numbers by pressing the ▲ and ▼
-buttons.
To set the displayed job number to the active job number press the green start button.
2.1
OPTIONAL: Entering a new job number with the help of the letter field
Press the enter button to activate the letter field for input of the job number. Now you can, as
described in the previous section, enter a new job number. The current job number is displayed.
Now you can enter a new job number. Confirm your the input by pressing the green start button or
cancel the function by pressing the red stop button.
Your entry will then be copied to the internal list and set as active job number. Close the job
number selection by pressing the green start button.
*) Only with electrofusion control units that have data recording capability.
Job no.
+++++Job ++++
2
