44
EN001 H01
Attention!
The prompt for deletion of the transferred reports only appears if "Secure data" is deactivated in the
system configuration.
Step
Action
7 OPT
OPTIONAL: With printing the system configuration
7.1
If you want to print the current system configuration, press the green start button. The following
display is shown:
Data transmission was successful.
7.2
OPT
OPTIONAL: After the data transmission the following display is shown:
8
OPTIONAL: Deletion of the transferred reports
8.1
OPT
OPTIONAL: If you want to erase the reports, press the enter button. A confirmation prompt "Are
you sure?" will be displayed. OPTIONAL: Confirm this prompt by pressing the green start button.
The reports will be deleted and the electrofusion control unit again shows again the main display.
Prompt for deletion after the data transfer
If you chose the job number printing you are offered the possibility to erase the reports that are
stored under a single job number.
8.2
OPT
OPTIONAL: Press the red stop button to leave the reports in the memory of the device. The
electrofusion control unit will then show the main display again.
Attention!
The prompt for deletion of the transferred reports only appears if "Secure data" is deactivated in the
system configuration.
Attention!
The deletion can take up to a couple of minutes.
To avoid possible errors in the memory management or loss of data, ensure that the
electrofusion control unit is not cut off from power during deletion of the reports. This could
lead to the destruction of the electronics!
NEVER switch the electrofusion control unit off during the deletion of welding reports.
Data transfer OK
Erase ?
