PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 766 / 892

Lower roller fitting
1 . Apply MP grease onto each of the sliding sec-
tions.
2 . Fit the guide roller pin and the lower roller on the
lower roller arm, using an Allen wrench.
3 . Fit the lower roller arm on the door with the two
relevant bolts.
4 . Remove the jack under the door panel.
Central hinge fitting
1 . Apply MP grease onto each of the sliding sec-
tions.
2 . Fit the guide by tightening the three relevant
nuts.
3 . Fit the central hinge by tightening the two rele-
vant bolts.
4 . Fit the limit switch by tightening the two relevant
bolts.
5 . Fit the central guide upholstery.
6 . Remove the jack.
Chassis
PORTER 1.3 16V
CH - 766