PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 732 / 892

Smontaggio
Hydraulic pump and electric motor removal
Before carrying out this operation, it is necessary
to lift the tipper, position the safety prop, release
the jack from the tipper and take it to the rest po-
sition.
Disconnect the oil fitting pipe on the pump, pay at-
tention to any possible oil leaks.
Disconnect the negative cable (-) from the battery.
Disconnect the pump unit electric motor power
supply cable.
Disconnect the pump unit motor remote control
switch excitation cable pin.
Remove the safety screw and disconnect the con-
trol pin of the solenoid valve for the jack descent.
Undo the two screws supporting the hydraulic
pump which can be accessed from the vehicle
right side. During this operation it is necessary to
hold the pump, as the two screws are indeed the
only connections between the hydraulic pump and
the vehicle chassis.
Smontaggio particolari
Removal of pump parts
Place the pump body in a vice. Undo the screws
locking the two plates which support the oil reser-
voir, remove the clamp and the reservoir also tak-
ing out the O-ring.
Slide off the oil intake pipe taking it out from its
seat.
Tipper version
PORTER 1.3 16V
VR - 732