PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 49 / 892

G . Pour coolant in the radiator. When the coolant
starts coming out through hole 2 located on the
engine side and through the heater bleed pipe,
close both openings.
H . Pour coolant until the fluid comes out through
the radiator fill opening.
I . Close the radiator cap 3 completely.
L . Clean the expansion tank internal side. Fill up
with coolant.
M . Start the engine and warm it up to the operating
temperature.
N . Make sure there are no leaks.
O . After the fluid temperature decreases, remove
plug 2 located on the engine side. Check the cool-
ant level. If the level is too low, add coolant. Tight-
en plug 2 again.
DURING THIS PHASE, NEVER OPEN THE RADIATOR CAP
3 SO THAT COOLANT DOES NOT COME OUT THROUGH
CAP 2.
KEY:
1. Radiator cap
2. Radiator cap
3. Radiator cap
4. Radiator
5. Engine
P . Check the coolant level in the expansion tank.
Add water until the maximum level is reached. Re-
fit the expansion tank cap.
PORTER 1.3 16V
Maintenance
MA - 49