PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 134 / 892

•
Turn the ignition key to "ON"; the status LED comes on for 0.5 seconds.
•
During this period, press key No. 2 of the radio control.
•
Leave the vehicle and press key No.1 of the radio control.
•
The alarm is activated with light and sound signals, as previously described, which are not
activated in case of a break-in attempt.
THE SIREN SOUND EXCLUSION IS LINKED TO EACH SINGLE ACTIVATION CYCLE. WE REC-
OMMEND THIS FUNCTION TO BE APPLIED WHEN NEAR HOSPITALS.
3. Activation without sensors and comfort control
This function allows userS to activate the alarm system without external sensors and comfort control.
The exclusion concerns any wire sensor connected to the alarm system (ultrasounds, super-high fre-
quency, impact).
Besides, if volumetric sensors via radio are installed via radio (section 7709), the following procedure
also includes such sensors.
Press key No. 1 of the radio control and, during the first 25" of the activation neutral period, press key
No. 2 of the radio control.
Following such operation, the turn indicators flash once and the sensors are subsequently excluded.
N.B.
THE PROCEDURE DESCRIBED ABOVE IS LINKED TO EACH SINGLE ACTIVATION CYCLE.
4. Alarm activated
Once the neutral period has finished (approx. 45 seconds), the system is "armed", or rather ready to
detect a break-in attempt.
The LED flashes intermittently to signal that the system is completely armed.
Any break-in attempt is signalled when the alarm with light/sound alarms is deactivated (see the relevant
section).
5. Alarm, neutral period and alarm cycles
As previously described, break-in attempts are signalled by the system with light/sound alarms.
Once the alarm cause is over, before another possible warning, there is a "neutral period" of 5 seconds,
useful to deactivate the system using a pin-code.
The alarm causes have a limit of 5 cycles, lasting 30 seconds each, for each entry and each activation
cycle.
The only alarm causes which are unlimited are the starting attempts (live positive, +15/54) and the cable
cut.
THE ALARM CYCLE CAN BE INTERRUPTED, WITHOUT DEACTIVATING THE SYSTEM, BY
PRESSING KEY No. 2 OF THE RADIO CONTROL.
6. Alarm deactivation
Press key No. 1 of the radio control and insert the electronic key in the appropriate hole. The turn
indicators flash three times and the siren sounds three times to signal deactivation.
If an alarm condition is detected, the turn indicators flash five times and the siren sounds five times. For
causes and related warnings, see the relevant section.
7. Emergency deactivation with pin-code
Electrical system
PORTER 1.3 16V
ES - 134