PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 359 / 892

2. Screw the oil filter until the gasket makes con-
tact with the oil pump.
3. Then, turn once more the oil filter completely
(360°).
Sensore pressione olio
Oil pressure warning light
Check if the oil pressure warning light turns on by
turning the ignition switch to ON.
- IF THE WARNING LIGHT DOES NOT TURN ON, CHECK
THAT THE BULB IN THE PANEL IS NOT BURNED. (REFER
TO THE SECTION "ELECTRICAL SYSTEM COMPONENTS"
- IF THE WARNING LIGHT TURNS ON WHEN THE ENGINE
IS RUNNING, CARRY OUT THE FOLLOWING CHECKS:
(FIRST OF ALL, MAKE SURE THAT THE ENGINE OIL IS AT
AN ADEQUATE LEVEL).
pressure switch fitting
1. Clean the threaded part of the pressure switch.
Wrap a sealing tape around the threaded part.
N.B.
- THE NEW PRESSURE SWITCHES ARE COATED WITH
SEALANT. THEREFORE, WHEN THE PRESSURE SWITCH
IS REPLACED WITH A NEW ONE, FIRST, REMOVE THE
COATING COMPLETELY SINCE THE PRODUCT LOOSES
ITS CHARACTERISTICS WITH TIME. ALSO CLEAN THE
THREADED HOLES WHERE THE SWITCH IS FITTED.
PORTER 1.3 16V
Engine
EN - 359