PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 749 / 892

4. Remove the lock block by taking out the relevant
retainer.
5. Remove the outside handle by undoing the two
nuts.
Installation
1. Fit the outside handle by screwing the two nuts
A .
2 . Fit the lock block with the relevant retainer
3 . Fit the lock by screwing the three screws.
N.B.
- APPLY MP GREASE ON EACH OF THE SLIDING SEC-
TIONS SHOWN IN FIGURE B.
4 . Fit the door opening control tie rod.
5 . Fit the door locking knob.
6 . Fit the door upholstery panel and the relevant components.
N.B.
AFTER FITTING, CHECK AND ADJUST THE LOCK.
PORTER 1.3 16V
Chassis
CH - 749