PIAGGIO PORTER 1.3 16V 2008, Service Manual

Page: 167 / 892

9 . Fit the camshaft sensor cover.
10. Fit the camshaft sensor on the head, and tight-
en the fixing bolt.
11. Check the ignition timing and adjust it if nec-
essary.
Locking torques (N*m)
Camshaft sensor - Cylinder head
15÷22
Accensione
Ignition timing
1. Set the ignition switch to OFF and connect the
following specific tool to the DLC A (Data Link
Connector) located at the lower part of the instru-
ment panel.
2. Connect a rpm indicator to the REV terminal,
using the following specific tool.
Specific tooling
020618Y Cable harness for connecting the
OBD Connector and the Diagnostic Tester
09991-87402-000 Rpm indicator pulse pickup
wire (Engine speed measurement)
3. Heat the engine.
4. Connect the stroboscopic light clamp to the ig-
nition coil of cylinder No.1 or No.4.
KEY:
A= Probe
B= Ignition coil
USE A STROBOSCOPIC LIGHT WITH INDUCTION
CLAMPS CALIBRATED AS PER THE HV COIL PRIMARY
SIGNAL.
PORTER 1.3 16V
Electrical system
ES - 167