Perkins New 1000 Series, Workshop Manual, Page: 80 / 290

14
80 Workshop Manual, TPD 1350, issue 3
New 1000 Series
Crankshaft pulley
To remove and to fit - four cylinder
engines
14-1
To remove
1 Remove the drive belt(s), see operation 23-3.
2 Release the three setscrews (A2 which hold the
pulley and remove the setscrews), the thrust block
(A1) and the pulley (A3).
3 Clean the components and check for damage.
Renew damaged components.
To fit
1 Put the pulley in position on the crankshaft.
Lubricate lightly the threads of the setscrews with
engine lubricating oil. Lubricate the main lip of the
seal with clean engine oil. Fit the thrust block and the
setscrews and tighten the setscrews gradually and
evenly to 115 Nm (85 lbf ft) 11,8 kgf m.
2 Check each setscrew again to ensure that they are
still to the correct torque.
3 Fit the drive belt(s), see operation 23-3.
1 2
3
A
A0357
Purchased from www.WorkshopManuals.co.uk