Perkins New 1000 Series, Workshop Manual, Page: 243 / 290

Workshop Manual, TPD 1350, issue 3 243
21
New 1000 Series
To remove and to fit - pressed steel
cover type
21-13
Some of the latest six cylinder engines are fitted with
oil cooler with a pressed steel cover.
To remove
1 Drain the cooling system, refer to the User's
Handbook.
Warning! The engine oil may be hot, allow the
engine temperature to cool down before the oil pipes
are released.
Caution: Do not remove both of the oil pipes
together.
2 Put a drip tray under the oil cooler and remove the
lubricating oil pipes from the oil cooler. Do not remove
both of the oil pipes together. Remove one of the
pipes, then fit the flanges (A4) and nuts (A5) onto the
studs again, before the other pipe is removed. This
will ensure that the element (A6) is fastened to the
cover when the assembly is removed.
3 Discard the "O" rings (A1).
4 Release the fasteners (A2) from the cover of the oil
cooler and remove the oil cooler assembly (A3).
Continued
A
A0397
1
2
3
4
5
6
Purchased from www.WorkshopManuals.co.uk