Perkins New 1000 Series, Workshop Manual, Page: 281 / 290

Workshop Manual, TPD 1350, issue 3 281
24
New 1000 Series
Adaptor for a hydraulic pump or a
steering pump with a splined drive
To remove and to fit 24-3
To remove
1 Release the cap screws and remove the adaptor
assembly from the rear of the timing case.
2 Check the gear, the spline and the bearings for
wear and other damage and renew the components
as necessary.
To fit
1 Fit a new "O" ring (A6) in its recess in the housing
(A5) and lightly lubricate it with clean engine
lubricating oil. Lubricate the bearings (A2) and (A7)
with clean engine lubricating oil. Fit the adaptor
assembly to the timing case and tighten the cap
screws.
To dismantle and to assemble 24-4
Consumable products:
POWERPART retainer (oil tolerant)
To dismantle
1 Remove the hydraulic pump or steering pump.
2 Remove the adaptor assembly , see operation 24-3 .
3 Remove the circlip (A4). Provide a support for the
flange face of the housing (A5). Use a suitable
adaptor on the front bearing (A7) to press the gear
and bearings out of the housing.
4 Remove the bearings from the gear (A3) with a
suitable gear puller.
A
A0288
6 5
4
3
2
1
1
7
Purchased from www.WorkshopManuals.co.uk