PerkinElmer 200A Series, User Manual

Page: 83 / 172

Operation
83
LEAK SENSOR (OFF=0, ON=1)
1
You can select use (1) or no-use (0) of the leak sensor.
Press numeric key (0 or 1, usually input 1) and then ENT key.
™
Default value: 0
™
When use (1) of the leak sensor is selected, an error message will be indicated upon
detection of liquid leakage. (Refer to Section 5.7.)
v. Leak sensor setting is now completed and the 1st monitor screen returns.
d. Setting the LAMP
ON or OFF status of the xenon lamp is selectable in the following way.
i. Press the UTLTY key.
ii. The following display will be presented.
<Utility initial screen>
UTILITY (OFFSET=1, TIME CONSTANT=2,
_5
USE PROG=3, PMT VOLT=4, OTHERS=5)
Select OTHERS.
Press numeric key 5 and then ENT key.
iii. The following display will be presented.
<Others setting screen>
OTHERS (Em BANDWIDTH=1, ERROR OUT=2,
4
LEAK SENSOR=3, LAMP=4)
Select LAMP.
Press numeric key 4 and then ENT key.
iv. The following display will be presented.
<Xe lamp selecting screen>
Xe LAMP ON/OFF (OFF=0, ON=1)
1
Select ON (1) or OFF (0) status of the xenon lamp.
Press numeric key (0 or 1, usually input 1) and then ENT key.
* Default value: 1
v. Xenon lamp setting is now completed and the 1st monitor screen returns.
When the xenon lamp is lit, Xe is displayed for LAMP. And when the lamp is
extinguished, OFF is displayed for LAMP.