PerkinElmer 200A Series, User Manual

Page: 103 / 172

Operation
103
vi. When the setting for the second step is completed, return to the TIME
setting on step setting screen.
™
If more parameters will be changed, then repeat the operation in this subsection. If
parameters will not be changed, advance to the final step setting.
f. Setting of final step of time program:
i. Set the measurement end TIME.
<Step setting screen (TIME indicated)>
TIME Ex Em BASE PMT
_ 20.0
1
Press numeric keys followed by ENT and then ESC key.
™
Setting range: 0 to 600 minutes, in increments of 0.1 minute
™
Items other than TIME need not be set.
ii. When the time program settings are completed, return to the 1st monitor
screen.
g. Addition of steps
Press the INSERT key to add a step to the program during step input. The step setting
screen will appear, so make the addition in the same procedure as described above.
However, the addition must be made within the time entered at the final step.
2. Start of Time Program
Press the START key to start the time program.
Status indication on the 1st monitor screen becomes R (time program is running), and
the elapsed time is indicated at TIME. The PROG. RUN LED lights up in green.
<1st monitor screen>
TIME Ex Em FL PROG LAMP [R]
*** 250
350 0.0 1 Xe
3. Stopping the Time Program
Press the STOP key, then the time program under execution stops and the 1st monitor
screen returns.
4. Examples of Time Program Operation
a. Setting of time program